![]() Carefully engage distributor driven gear with camshaft drive gear so when distributor is installed properly, rotor aligns with reference mark.Ģ) Install hold-down clamp and bolt but do not tighten. NOTE: If engine has been rotated since distibutor removal, return engine to TDC.ġ) Clean mounting surface. Carefully engage distributor driven gear with camshaft drive gear so when distributor is installed properly, rotor aligns with reference mark.Ģ) Install distributor cap. Lift distributor fromġ) Position distributor in engine. Disconnect camshaft position sensor harnessĬonnector. Reference to indicate rotor and distributor housing position when Scribe mark on distributor and adjacent component as ![]() 1 of distributor cap and engine is at TDC. Rotate engine crankshaft until distributor rotor is pointing towardĬylinder No. Since a conventional timing light can not be used to adjust distributor after installation, ensure distributor is returned to its original position.ĭisconnect negative battery cable. Base ignition timing and timing advance are controlled by the PCM. If component removal and installation is primarily an unbolt and bolt-on procedure, only a torque specification may be furnished.ĬAUTION: Base ignition timing is not adjustable on any 2.5L, 4.0L or 5.2L engine. ![]() Removal, overhaul and installation procedures are covered in this article. Jeep Cherokee, Grand Cherokee, Grand Wagoneer, Wrangler ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |